This is an old revision of the document!

Team A - single MPPC (Drafting)

MPPC models: S13081-050CS(X1), 4 pieces

Three main objectives

MPPC characteristics (noise, noice coincidence, electric gain)
Speed of light in the optical fibers/ Concept of TOF. We need to use very fast optical pulsing for this measurement to get more precise measurement. Will try to use LED-driven Beacon to get a pulse in ~ 2-4ns width
Cosmic ray muons: rate, and light yield

Oscilloscope for signal recording and digitalized
- It is connected via Ethernet and allowed to remote control from a PC
- PC (IFIRSE #5, Ubuntu) is allocated
4 pieces of single MPPC
DC PS for MPPC
Circuit board to be soldered by students, to provide voltage and get the signals
For LED Beacon, need other DC PS and Analog Discovery as function/waveform generator for trigger
Plastic scintillator and wavelength shifting fiber
Optical beam splitter and optical connectors

Low operation voltage (~53V - 70V)
High multiplication ratio (gain) (1e → ~10⁶e)
High photon detection efficiency (up to ~50% at peak sensitivity wavelength)
Fast response (a few nanosecond) and good time resolution
Wide spectral response range (wavelength ~270nm - 900nm)
Not affected by magnetic fields
Highly resistant to mechanical shocks, and does not suffer from “burn-in” by incident light saturation

The structures of all the pixels in an MPPC are the same and every pixel consists of an avalanche photodiode and a quenching resistor
When one photon comes to a pixel in the MPPC, it will produce one pulse
If more than one photon are detected by different pixels at the same time, the MPPC output will be a pulse which is a superimposed of the output pulses of those pixels