Differences

This shows you the differences between two versions of the page.

--- teamb2023 [2023/02/26 09:38] – [Hands-on Activities] nuicise
+++ teamb2023 [2023/03/19 22:02] (current) – [Team B] nuicise
@@ Line 11: / Line 11: @@
   * Nguyen Thi Nhung
+[[https://ifirse.icise.vn/nugroup/hardwarecamp/uploads/Hardware_Camp_Beamer-GroupB.pdf|Group B Final presentation]] and [[https://ifirse.icise.vn/nugroup/hardwarecamp/uploads/GroupB%20-%20Hardware%20Camp%20Report.pdf|final report]]
 ===== Targets =====
   * **MPPC properties**
@@ Line 32: / Line 33: @@
 . Act#1 (1.5h, Feb. 27 AM): safety, lab arrangement, components, rules; light source (LED)  driven with waveform generator, arduino or analog discovery; various LED wavelength; soldering a circuit for LED (this is to use with MPPC later, so think a bit about design to easily coupling to MPPC (direct or with optical fibers, mimicking the use of the WLS))
-. Act #2 (1.75h, Feb. 27 PM) oscilloscope, signal generation with analog discovery, counting function
+. Act #2 (1.75h, Feb. 27 PM) oscilloscope functionality, signal generation with analog discovery, counting function  and coincidence pattern trigger
-. Act #3 (2.75h, Feb. 28 AM): MPPC circuit; soldering, testing signal, pedestal; noise mitigation with Faraday case
+. Act #3 (2.75h, Feb. 28 AM): Single MPPC circuit; soldering, testing signal, pedestal; noise mitigation with Faraday case, checked if can see single P.E without amplifier?
-.  Act #4 (2.75h, Feb. 28 PM): Light tightening; MPPC characteristics (noise rate, gain, supply voltage dependence; timing response); measure the speed of light in the optical fibers if having time (concept of light detection and ranging or LiDAR in short); NIM modules to use: disciminator and scaler
+.  Act #4 (2.75h, Feb. 28 PM): Start working with MPPC array; measure MPPC characteristics (noise rate, gain; timing response); measure the fluorescence lifetime with Thorlabs fluorescence plates
-.  Act #5 (2.75h, Mar. 1 AM): Work in combination of Scintillator, wavelength shifting fiber and photosensor; concept of muon counter; NIM modules to use: discriminator, scaler, coincidence (and delay if needed)
+.  Act #5 (2.75h, Mar. 1 AM): Continue with fluorescence lifetime measurement if needed. measure coincidence rate. Work in combination of Scintillator, wavelength shifting fiber and photosensor; concept of muon counter; NIM modules to use: discriminator, scaler, coincidence (and delay if needed)
 .  Act #6 (2.75h, Mar. 1 PM): Data taking and analysis